| Q: |
What
is Bio-Diesel? How can it be manufactured? |
| A: |
Bio-Diesel is an eco-friendly, alternative diesel
fuel prepared from domestic renewable resources i.e.
vegetable oils and animal fats. These natural oils and
fats are made up mainly of triglycerides. These triglycerides
when reacted chemically with lower alcohols in presence
of a catalyst result in fatty acid esters. These esters
show striking similarity to petroleum derived diesel
and are called "Bio-Diesel". |
| |
|
| Q: |
What are the
plant species that are suitable for preparation of Bio-Diesel?
What size of Bio-Diesel plant works out to be economical?
|
| A: |
In the US bio-diesels are mainly derived from Soybean
oil and in Europe from the Sunflower oil. However, as
India is deficient in edible oils, non-edible oils may
be material of choice for producing Bio-Diesel like
Jatropha, Karanjia and Rice bran oils, etc. Since, in
India bio-diesel is in research phase, so, economics
would only be generated later. |
| |
|
| |
Top |
| Q: |
What are the
advantages of Bio-Diesel for a country like India? |
| A: |
Bio-Diesel has been more attractive recently because
of its environmental benefits and the fact that it is
made from renewable sources and can be prepared locally.
Since India is deficient in edible oils, therefore,
the non-edible oil like Karanjia, Jatropha, etc. could
be the desirable source for India for production of
bio-diesel. These plants could be grown on wasteland,
about 80 million hectare of which is available in India
. These crops grow in arid and semi-arid region and
require almost no post plantation management and care.
Since, all most all the wasteland is available in rural
and economically underdeveloped region, the large-scale
bio-diesel production has an enormous potential for
employment and development of these areas. |
| |
|
| Q: |
How compatible
is the Bio-Diesel with the vehicle and pump engines? What
are the changes that are required to be made in the engine?
|
| A: |
The major application of Bio-Diesel is in transportation
sector as an alternate to mineral diesel. Many automobiles
builders like Ford, John Deere, Massey-Ferguson, Mercedes,
BMW, Volkswagen, Volvo, etc have accepted Bio-diesel
as the fuel suitable for their vehicles in the existing
diesel engines. However, mostly Bio-diesel is used in
10% or 20% blends rather than as neat Bio-diesel. This
blending approach also avoids the need to build a separate
& costly infrastructure for storing Bio-diesel.
Though Bio-diesel is recommended for use in almost all
diesels run vehicles, the fuel must meet the ASTM/DIN
specifications. |
| |
Top |
| Q: |
What made
IOC take up research in Bio-Diesel? Is the technology
and the product a proven success? |
| A: |
The depletion of the world petroleum reserves coupled
with the global environmental problems stimulated the
search for the alternative source for petroleum fuel.
Bio-Diesel is one of such candidates for the exploitation
as an alternative to diesel fuel. In laboratory process,
the Bio-Diesel prepared, has been evaluated for various
physico-chemical properties. Subsequently, we have successfully
scaled up the production of Bio-Diesel at pilot scale
(60 lit) at IOC (R&D) Centre. The product obtained
has been evaluated for various physico-chemical properties
and it was found that the synthesized Bio-Diesel meets
the ASTM bio-diesel specification. Field trials and
emission testing of Bio-diesel is being pursued at IOC
(R&D) Centre. |
| |
|
| Q: |
What are the
areas in the country wherein cultivation of species suitable
for manufacturing Bio-Diesel can be taken up? |
| A: |
As discussed above, that Bio-Diesel will be manufactured
in the rural areas because of the wasteland and cheap
labor availability. More precisely, it will depend upon
the wasteland locations in the country. |
| |
Top |
| Q: |
What is the
present status of Bio-Diesel research under IOC? By when
would the technology become commercially available? |
| A: |
IOC (R&D) has examined and optimized the synthetic
processes for the preparation of Bio-Diesel from various
vegetable oils, which include oils from Rice bran, Jatropha
curcas, Palm, Karanjia, Sunflower etc. using methanol
and ethanol as alcohol. In laboratory process, the Bio-Diesel
prepared, has been evaluated for various physico-chemical
properties. Subsequently, we have successfully scaled
up the production of Bio-Diesel at pilot scale (60 lit)
at IOC (R&D) Centre. The product obtained has been
evaluated for various physico-chemical properties and
it was found that the synthesized bio-diesel meets the
ASTM bio-diesel specification. Field trials and emission
testing of Biodiesel is being pursued at IOC (R&D)
Centre. |
| |
|
| Q: |
Why Bio-diesel
is important for Indian Railways? |
| A: |
Indian Railways is the largest user of diesel, about
two million MTPA. Indian Railway is also owner of very
large area of land, which presently is without organized
plantation. Railways have shown interest to plant the
Bio-Crops along the rail tracks and other land available
and it is estimated that the railways can produce enough
Bio-diesel to replace about 5 to 10% of diesel required
for their use. Introduction of bio-diesel in Railways
may serve two objectives. Firstly, lowering of emissions
and secondly providing enough lubricity to the diesel.
The lubricity of low sulphur diesel is likely to cause
concerns in near future when the sulphur level of diesel
will fall below 500 ppm. Bio-diesel at 1-2% level in
petrodiesel will retain the lubricity of the low sulphur
fuel. |
| |
Top |
| |
Set up of Plant - Bio-Diesel |
| |
The Bio-Diesel production involves mainly two steps:
|
| |
- Extraction of oil from the seeds
- Conversion of vegetable oil to bio diesel
|
| |
The extraction of oil can be done in any suitable
oil extraction unit.
Commonly used oil extraction units can be used for extraction
of oil from jatropha and karanja as well. The second
step of conversion of vegetable oil to bio diesel requires
chemical processing plant. The operation of this plant
requires specific training and this can be done by well
trained engineers/ diploma holders/chemists. |
| |
|
| |
Resources Available |
| |
IIT Delhi, IICT Hyderabad, ITL Faridabad and Delhi College of Engineering, New Delhi have developed technology for production of Bio-Diesel from vegetable oil. These institutions can be approached for getting know-how about the process. |
| |
Top |
| |
Reply to Queries |
| |
- Plant can be set up by a group of people or by entrepreneurs
on small scale. For terms and conditions, these institutes
may be contacted.
- Training is available at ITL Faridabad as part of
technology package. Other institutes may also be contacted.
- Exact details for resources shall be available at
above mentioned institutes.
- Detailed procedure is enclosed.
|
| |
Detailed Procedure for Production
of Bio-Diesel |
| |
Trans-esterification also called alcoholysis, is
the displacement of alcohol from an ester by another
alcohol in a process similar to hydrolysis. This process
has been widely used to reduce the viscosity of triglycerides.
The transesterification reaction is represented by the
general equation, which is the key reaction for Bio-Diesel
production.
RCOOR’ + R” RCOOR” + R’OH
If methanol is used in the above reaction, it is termed
methanolysis. The reaction of triglyceride with methanol
is represented by the general equation. |
| |
 |
| |
Triglycerides are readily trans-esterified in the
presence of alkaline catalyst (Lye) at atmospheric pressure
and temperature of approximately 60-70 0C with an excess
of methanol. The mixture at the end of reaction is allowed
to settle. The excess methanol is recovered by distillation
and sent to a rectifying column for purification and
recycled. The lower glycerol layer is drawn off while
the upper methyl ester layer is washed with water to
remove entrained glycerol. Methyl esters of fatty acids
are termed as bio-diesel. |
| |
Top |
| |
Quality Control |
| |
Thus Bio-Diesel prepared should meet the International
standards given below:
Specifications (ASTM D 6751-01) For Bio-Diesel (B100)
|
| |
| |
D
- 6751 |
|
| Flash
point (°C) |
D
- 93 |
Min
130 |
| Phosphorus
(% Mass) |
D
- 4951 |
Max
0.001 |
| Water
& sediment (% Vol) |
D
- 2709 |
Max
0.050 |
| CCR
100% (% Mass) |
D
- 4530 |
Max
0.050 |
| Sulphated
ash (% Mass) |
D
- 874 |
Max
0.020 |
| Viscosity
at 40°C (CST) |
D
- 445 |
1.9
- 6.0 |
| Sulphur
(% Mass) |
D
- 5453 |
Max
0.05 |
| Cetane
number |
D
- 613 |
Min
47 |
| Copper
corrosion |
D
- 130 |
Max
3 |
| Neutralization
Value |
D
- 664 |
Max
0.80 |
| Free
glycerin (% Mass) |
D
- 6584 |
Max
0.020 |
| Total
glycerin (% Mass) |
D
- 6584 |
Max
0.240 |
| Distillation
Temp. (°C) |
D
- 1160 |
90%
at 3600C |
|
| |
Top |